When making audio speakers, most of the frequency dividers use commercially-available finished products, but the frequency dividers sold on the market are uneven, and the quality is mostly more than one hundred yuan, which is not acceptable to junior enthusiasts. The quality of the frequency divider whose price is below tens of yuan is difficult to guarantee, and the actual use is mediocre. The self-made frequency divider can be used for less investment in exchange for larger gains. After practice, the author explored the method of making frequency dividers in amateur, and used self-made frequency dividers to perform well in the sound system.
1. Material preparation According to the design of the frequency divider schematic, prepare the following materials:
1. According to the requirements of the inductance coil, select the non-metallic skeleton, such as solder wire, plastic skeleton of the raw tape for sealing, and other wooden and colloidal skeletons.
2. Select the enameled wire with appropriate thickness and high quality (I chose the enameled wire removed from the starter switch of the car).
3. Resistor-capacitor parts choose capacitors and resistors with appropriate capacity, resistance and power according to circuit requirements. It is best to use imported or domestic high-quality CBB capacitors for frequency-dividing capacitors. High-power cement resistors are the first choice for resistors.
4. Adhesive This agent can be selected from commercially available "Ridoku" and other strong viscosity adhesives.
5. For coins and bolts, choose a copper product with a diameter of about 4 mm, and the length depends on the height of the inductor frame.
6. According to the number of frequency-divided components, choose a high-quality copper-clad plate of appropriate size. The direction of the circuit is carved with a utility knife according to the design requirements.
7. A plate of transparent tape.
2. Production 1. Around the inductor, drill a small hole with a diameter slightly larger than the enameled wire in the middle of the top and bottom of the adhesive bottle (because the liquid is viscous, it will not flow out of the hole), and wear a piece of plastic hose in each hole , Put the enameled wire through the two hoses to ensure that the enameled wire will not be scratched when passing through the two holes, then one person will tighten the end of the enameled wire, and the other person can take the other end of the enameled wire and wind it on the skeleton. Enameled wire, because the enameled wire has been evenly coated with a layer of adhesive when passing through the adhesive, you can use your hands to pinch the two ends of the skeleton to rotate it. Lead out the wire, and after the adhesive on the wire solidifies, wrap several layers tightly on the coil with transparent tape.
2. Component installation According to the position of the inductance coil and the resistance-capacitance piece on the board, make a hole in the board with a small drill, drill a hole slightly larger than the diameter of the copper bolt in the middle of the coin, and then pass the copper bolt through the coin, Coil and circuit board, and then pad with spring washer, fasten with nut, scrape the coil, capacitor and resistance leads to tin, solder them to the corresponding position, and finally solder the inlet and outlet wires on the board.
After the above operation, a high-quality and inexpensive crossover is completed, and the rest is the joy of success.
Inductor wiring of the frequency divider pays attention to the connection method of the inductance coil in the frequency divider of the speaker, which has a great influence on the sound quality and timbre. The pair of inverting speakers used, the inductive coil connection method is the outer circle into the inner circle (pictured), the sound is balanced and round. I used the inner circle to the outer circle connection, but the bass was completely absent.
Die-Casting Products,Led Housing Die Casting,Aluminum Die Casting Product,Aluminum Die Casting Led
Yangzhou Huadong Can Illuminations Mould Manufactory Co., Ltd. , https://www.light-reflectors.com